High Temp Velcro Installation

Installing Velcro (HIGH TEMP VELCRO)



  • THIS VELCRO ADHESIVE IS ACTIVATED WITH ACETONE (NOT SUPPLIED) USE RECOMMEND PPE FROM ACETONE COMPANY WHILE IN USE!!! 
  • Clean Hardtop with the acetone and a lint free rag, ensure your hard top is clean and grease free. 
  • Cut 4-5 Velcro strips per panel to length of Headliner with a pair of scissors and plan position on hard top
  • Using a small bowl or container (note: acetone will eat some plastics, use metal or glass) , submerge 1 velcro strip in the Acetone for 5 seconds. Back of the Velcro will become tacky fast.
  • Place strip in desired location and Press Fimary all across the length of it to help ensure all the air is pushed out as well as excess Acetone. 
  • Continue same process until all strips are applied
  • Allow 24 hours for full bond strength.
  • After 24 hours headliners can be installed. 

    Installing Headliner, with hardtop on vehicle

  • For the Rear Gladiator Headliner or The Back seat Wrangler Headliner, Cut a piece of Cardboard or similar material approximately 21 inches by 10 inches. 
  • Install the cardboard cut out on top of the soundbar 
  • Slide MOLLE headliner in between cardboard and soundbar 
  • Position the label side of the MOLLE Headliner to your desired location and start pressing the headliner to the velcro starting at the label. When you get closer to the sound bar remove cardboard and continue to press down. Enjoy your Invictus Off Road MOLLE Headliner!
  • FOR ALL OTHER HEADLINERS
  • Align headliner and press on to Velcro, ensure each section of hook and loop has been pressed firmly together. 
  •