Installation will be easier with soft top pulled back or freedom panel removed, however this is not necessary.
Install MOLLE cage wrap on roll cage note there are cutouts in the fabric that will line up with soft-top hardware locations.
Start by inserting the sewn portion of the nylon strap through a set of horizontal MOLLE cuts. Note there are multiple cuts to allow positioning of the grab handle on the roll bar.
Insert the G-Hook into the sewn loop and pull tight to roll bar.
Now the G-Hook on the opposite side of the strap can be snaked through a rear set of horizontal MOLLE cuts.
Connect the G-hook to the nylon strap to complete installation. Note the length of the grab handle can be adjusted using the Glide on the strap.
choosing a selection results in a full page refresh
